COB LED Strip Accessories
Learn which COB LED strip accessories you need to finish an installation: connectors, power supplies, mounting channels and the checks that keep a run working.
Contents
COB LED strip accessories are the parts that let a high density LED strip connect, receive power and sit neatly on a surface. A COB LED strip is a continuous line of tiny diodes on a flexible board, so its accessories differ from those of older strip types in wiring and heat handling. This page explains connectors, power supplies and mounting channels and how each one matches the strip.
Matching COB connectors to the strip
COB connectors join a strip to wires or to another strip without solder. Choose a connector rated for the strip width and for the current the run draws, because a loose fit creates resistance and heat. Some COB strips have a continuous phosphor surface that hides the contact pads, so check that the strip exposes pads where the connector grips. Clip-on connectors suit a quick join, while soldered joints hold better where the strip bends.
Sizing a COB power supply
A COB power supply converts mains voltage to the low voltage the strip needs, and its current rating must cover the whole run. Add the current of every strip segment on one supply, then allow headroom so the supply runs below its limit. Voltage drop grows along a long high density LED strip, so a supply placed at one end may leave the far end dim. Feeding power at both ends or using a thicker cable reduces that drop.
Mounting channels and heat
A COB mounting channel is an aluminum profile that holds the strip flat and carries heat away from the board. High density LED strip packs many diodes into a short length, so heat per inch is higher than on a sparse strip. Aluminum spreads that heat and keeps the strip cooler, which protects the diodes over time. A diffuser clipped over the channel softens the light and hides the strip surface.
Questions about COB LED strip accessories
Do COB LED strips need special connectors?
Yes, COB LED strips often need connectors made for their pad layout and width. A connector for a standard strip may not reach the pads on a COB board, because the continuous coating covers most of the surface. Match the connector to the strip width and current, and confirm that the pads are exposed where it grips.
Can I cut a COB LED strip anywhere?
No, a COB LED strip can be cut only at the marked cut points printed on the board. Cutting between those points breaks the circuit and leaves a dead section. Check the cut marks before you plan a run, and seal the new end with an end cap or connector.
Which power supply works with a COB LED strip?
The right COB power supply delivers the strip voltage and enough current for the full run. Read the strip rating for volts and amps per length, multiply by the length in use, and pick a supply above that figure. A supply with a metal case and ventilation handles heat better than a sealed unit at the same load.
Is a mounting channel necessary for a COB strip?
A COB mounting channel is not always required, but it helps wherever the strip runs at high output or sits on a surface that traps heat. Aluminum pulls heat from the board and holds the strip straight. On a short run at low output, a strip with good adhesive backing may be fixed directly.