How to Install Battery Puck Lights Step by Step
A clear step-by-step guide to installing battery puck lights: choosing a mounting surface, cleaning it, using adhesive or screws, and changing batteries.
Contents
- Choose the spot and check the surface
- Clean before you stick anything down
- Adhesive or screws, and fitting batteries
- Battery Puck Light Setup Questions
- Do battery puck lights need wiring?
- How do I install puck lights under a cabinet?
- Will adhesive backing hold a puck light on the wall?
- How do I change the batteries in a puck light?
Installing battery puck lights means choosing a spot, preparing the mounting surface, attaching each light with adhesive backing or screws, and fitting the batteries before you switch it on. The job needs no wiring, so you can place a battery-powered puck light under a shelf, inside a cabinet or on a wall where a cable would be awkward. The steps below cover setup, mounting and battery replacement in order.
Choose the spot and check the surface
Pick a mounting surface that is flat, solid and clean before you unpack the light. A smooth painted shelf, a cabinet underside or a tile face holds an adhesive backing well. Rough brick, loose plaster and dusty wood resist a sticky pad, so plan on screws there instead. Hold the light in place first and mark the outline with a pencil so you can judge the light spread.
Clean before you stick anything down
Cleaning the surface before sticking is the step that decides whether the light stays up. Wipe the area with a damp cloth and a mild detergent, then let it dry completely. Wipe again with an alcohol wipe and allow the surface to air dry for a few minutes. Press the adhesive backing firmly for several seconds once the light is in position.
Adhesive or screws, and fitting batteries
Screw mounting versus adhesive depends on the surface and on how often you expect to remove the light. Adhesive suits smooth faces and renter-friendly setups, while screws suit rough surfaces and heavier fixtures. Open the battery compartment, fit the cells the right way round, and close the cover before mounting. Check that the push switch works while the light is still in your hand.
Battery Puck Light Setup Questions
Do battery puck lights need wiring?
Battery puck lights need no wiring because each light runs on its own cells. You place the light where you want it and switch it on with the push switch. This makes a battery-powered puck light useful inside cabinets, under shelves and in corners away from an outlet.
How do I install puck lights under a cabinet?
Installing puck lights under a cabinet starts with a clean, dry underside and a test placement. Mark the outline, then either press the adhesive backing down firmly or drive the supplied screws into the cabinet base. Fit the batteries and check the push switch before the light is fixed in place.
Will adhesive backing hold a puck light on the wall?
Adhesive backing holds a puck light on a flat, smooth wall that has been cleaned and dried first. Dust, grease and dampness weaken the bond, so wipe the spot with alcohol and let it dry. On rough or painted surfaces that may shed, use screws instead of the pad.
How do I change the batteries in a puck light?
Battery replacement on a puck light starts by twisting or lifting the cover to reach the compartment. Take out the old cells and fit new ones in the direction marked inside the holder. Close the cover fully and test the push switch before you return the light to its mount.