Tape Measure Magnetic Tip: What It Is, Attachment and Replacement
Learn what a magnetic tape measure tip is, how the hook end attaches with rivets, and how to fit a replacement tip so the blade end holds on metal.
Contents
- How the magnetic hook works
- Attachment with rivets
- Replacing a worn tip
- Questions about magnetic tape measure tips
- Can I add a magnetic tip to a tape measure that has none?
- Where can I buy a tape measure magnetic tip attachment?
- How do I replace the magnetic tip on a tape measure?
- Does a magnetic tip change the accuracy of a tape measure?
A magnetic tape measure tip is a hook end fitted with a small magnet so the blade end stays put on steel studs, framing and ductwork while you pull the tape. The magnet lets you hook the tape to a metal edge without a second pair of hands, and the tip still works as a standard hook for measuring from an edge. This page explains how the tip is attached, how to add a magnetic tip yourself, and what a replacement involves.
How the magnetic hook works
The magnetic tip sits at the very end of the blade and holds the tape against ferrous metal. A small magnet is set into the hook end, often behind the hook plate, so the flat face grips a steel stud or beam. The hook still has the usual slot and lip that catch on a nail or a board edge. Pulling the blade away releases the magnet with a firm tug.
Attachment with rivets
The hook end is fixed to the blade with small rivets that pass through the hook plate and the blade. Rivets allow the hook to slide a little, which compensates for the thickness of the hook when measuring inside and outside. A magnetic tip attachment uses the same rivet points or clips over the existing hook. Removing rivets needs a drill or a file, and refitting them needs a rivet tool of the right size.
Replacing a worn tip
A replacement tip restores grip when the magnet loses strength or the hook bends out of true. Buy a tip made for the blade width of your measure, because a loose tip reads inaccurately. Check that the new rivet holes line up with the old ones before you take the old tip off. If the blade itself is torn at the rivet holes, a new tip will not sit flat and the measure should be replaced.
Questions about magnetic tape measure tips
Can I add a magnetic tip to a tape measure that has none?
Yes, a clip-on magnetic tip attachment fits over the existing hook end of many tape measures. The attachment adds a magnet at the blade end without drilling out the rivets. Check the blade width and hook shape, because a loose clip shifts the zero point. A clip that does not sit flush changes every reading you take.
Where can I buy a tape measure magnetic tip attachment?
A tape measure magnetic tip attachment is sold by tool retailers and online marketplaces that carry measuring accessories. Search for the attachment by the blade width of your measure rather than by brand alone. Confirm the listing shows the hook shape and the fitting method before you order. A part that does not match the hook cannot be riveted or clipped on.
How do I replace the magnetic tip on a tape measure?
A magnetic tip replacement means drilling out the old rivets, lifting the hook and fitting the new tip with fresh rivets. Support the blade on a block of wood so the drill does not bend it. Line up the new holes, set the rivets and check the hook slide before you retract the blade. A rivet that is too tight stops the hook from sliding and spoils inside readings.
Does a magnetic tip change the accuracy of a tape measure?
A magnetic tip keeps accuracy only if the hook slides by the same amount as the original. The hook is meant to move by its own thickness so inside and outside readings agree. A thick add-on magnet or a badly fitted replacement can shift the zero point. Test the measure against a known length after fitting a new tip.