Replacing Furniture Glides and Feet, Including Chair and Patio Pieces
How to identify, remove and install replacement furniture glides and feet for chair legs and patio pieces, including felt pads and threaded glides.
Contents
- Read the old glide before buying
- Removing worn glides and pads
- Fitting glides on chairs and patio pieces
- Questions about furniture glide replacement
- When do furniture glides wear out?
- Can I replace felt pads on chair legs?
- How do I choose the right glide size and thread?
- Do patio furniture glides need a different replacement?
Replacing furniture glides and feet restores a chair or patio piece that rocks, scratches the floor or sits unevenly. The worn pad or the damaged foot is the part that meets the floor, so swapping it is a small job that changes how the whole piece stands. This page explains how to match a replacement glide to the old one, how to remove what is left and how to fit the new part so it holds.
Read the old glide before buying
A replacement glide must match the old one in size, shape and fixing method. Check whether the part is a push-in leg tip, a nail-in glide, a screw-in glide or a threaded glide, because each needs a different socket or hole. Measure the diameter of the foot and the width of the stem or thread, since a loose fit will work its way out. Felt pads are measured by their width and thickness instead, and a worn pad replacement needs the same footprint as the one it covers.
Removing worn glides and pads
Old glides often come away with the fixing still in the leg, so removing old glides means clearing the hole as well as the surface. Pry a nail-in or push-in glide out with a thin lever, then pull any broken stem or nail with pliers. Scrape old adhesive and felt residue from the base of the leg until the surface is flat and dry. Treat a split or splintered leg as a repair job before you fit anything new, since a new glide will not hold in damaged material.
Fitting glides on chairs and patio pieces
Glide installation follows the fixing method of the part you bought. Press a leg tip on squarely, tap a nail-in glide in with light hammer blows, and turn a threaded glide by hand until it seats against the leg. Patio furniture glides live outdoors, so match the material to the frame and keep water from sitting in an open socket. Replacement chair glides should sit flush with the leg so the chair stands level on all feet.
Questions about furniture glide replacement
When do furniture glides wear out?
Furniture glides wear out when the pad flattens, cracks or falls off, or when a stem loosens in the leg. The signs are a chair that rocks, a scratch line on the floor or a metal foot touching the ground where a pad used to be. Replace the worn part as soon as the floor contact changes, because bare wood or metal on a leg will mark a hard floor.
Can I replace felt pads on chair legs?
Yes, you can replace felt pads on chair legs once the old pad and its adhesive are gone. Scrape the base clean, let it dry and press a new pad of the same width onto the flat surface. Felt pads suit smooth indoor floors, while a patio piece needs a hard glide or a foot made for outdoor use.
How do I choose the right glide size and thread?
Glide size and thread must match the socket already in the leg or the width of the hole. Measure the old stem or thread with a ruler, and compare the new part against the old one before fitting it. A threaded glide that turns in too easily is undersized, and one that will not start is the wrong thread.
Do patio furniture glides need a different replacement?
Patio furniture glides differ from indoor pads because they face water, grit and sun on a surface that stays outside. Choose a hard foot or a glide that seals the leg end so water cannot collect inside the frame. Loose or split glides on a patio chair let the leg take the wear, so replace them when the fit changes.