How to Measure a Lazy Susan Corner Cabinet

Learn how to measure a lazy susan corner cabinet: opening width, cabinet depth, carousel diameter and the clearance needed for the turntable to rotate freely.

3 min read1 views
— · 0 votes
Contents
  1. Record the opening before anything else
  2. Measure depth to the corner point
  3. Allow clearance for the turntable
  4. Questions about measuring corner cabinets
  5. How do I measure a corner cabinet for a lazy susan?
  6. What size lazy susan fits a corner cabinet?
  7. How much clearance does a rotating tray need?
  8. Should I measure the cabinet opening or the shelf itself?

Measuring a lazy susan corner cabinet means recording the cabinet opening width, the corner cabinet depth and the clear space inside before you order a turntable. You also check the door swing and the clearance for rotation, so the carousel diameter fits without rubbing the frame, hinges or shelf edges.

Record the opening before anything else

The cabinet opening width decides which turntables can pass through the frame during fitting. Measure the clear width between the cabinet sides at the front edge and again slightly deeper inside. Repeat the reading at the shelf level where the carousel will sit, since the sides can taper. Write each figure down rather than trusting one measurement taken in a hurry.

Measure depth to the corner point

Corner cabinet depth runs from the front face back to the inside corner of the unit. Hold the tape square to the front and read the full distance, then check the depth along both legs of the corner. A turntable sits inside the deepest usable point, so a shallow leg limits the carousel diameter more than the corner itself does. Note any pipe, wire or filler panel that reduces that depth.

Allow clearance for the turntable

Clearance for rotation is the free ring of space the carousel edge needs as it turns. With the turntable placed where you plan to mount it, check that no hinge, door edge or shelf support crosses that path. The carousel diameter must be smaller than the tightest distance across the space, measured through the center of the turntable. Fit the largest turntable that clears everything, and leave a small gap so the tray does not bind.

Questions about measuring corner cabinets

How do I measure a corner cabinet for a lazy susan?

Measuring a corner cabinet for a lazy susan starts with the opening width, the inside depth and the height between shelves. Measure the clear width at the front and at the mounting level, then measure depth to the inside corner along both legs. Choose a carousel diameter below the tightest of those figures and confirm the tray clears hinges and the door swing.

What size lazy susan fits a corner cabinet?

The lazy susan size that fits a corner cabinet is set by the smallest clear distance across the space, not by the cabinet's nominal width. A full round tray needs a diameter smaller than that distance, while a pie-cut or D-shaped tray uses the corner more closely. Measure the opening and the interior, then match the carousel diameter to the smaller reading.

How much clearance does a rotating tray need?

A rotating tray needs enough clearance to turn a full circle without touching the cabinet frame, hinges or shelf supports. Check the path of the tray edge at its widest point and keep a small gap all around it. Door swing matters too, because an open door that reaches into the cabinet can block a tall item on the turntable.

Should I measure the cabinet opening or the shelf itself?

Measure both the cabinet opening and the shelf, because each answers a different question about the lazy susan. The opening width tells you what can pass through the frame during installation, while the shelf dimensions show the space the turntable will occupy. A tray that fits the shelf but not the opening cannot be installed without removing the cabinet front.

Read next

Latest articles