Circuit Breaker Size for a Lighting Circuit
Work out the breaker amp rating for a lighting circuit from the load in watts, then match the cable size and pick the right overcurrent protection.
Contents
- Add up the lighting load first
- Match the breaker to the cable
- Choose the MCB type for lights
- Questions about lighting circuit breakers
- What size MCB for a lighting circuit?
- How do I work out the lighting circuit load in watts?
- Does the breaker amp rating have to match the cable size?
- Should a lighting circuit use a type B or type C MCB?
Circuit breaker size for a lighting circuit follows from the load the lights draw and the cable that feeds them. You add the watts of every lamp on the circuit, convert them to current at your supply voltage, and choose a breaker rated above that current but below the cable's capacity. The breaker then protects the wiring against overcurrent while the lights run normally.
Add up the lighting load first
The lighting circuit load in watts sets the starting point for any breaker choice. Add the wattage of every lamp and fixture that the circuit will supply at the same time, including any transformer losses for low-voltage fittings. Divide that total by the supply voltage to get the current in amps. A load close to the breaker rating leaves little room for extra fittings later.
Match the breaker to the cable
A cable size matched to breaker rating keeps the protection working as intended. The breaker must trip before the cable overheats, so its amp rating stays at or below the current the cable can carry in its installation method. Cable run through insulation or in a hot space carries less current than the same cable in open air. Check the cable's current rating for the way it is actually installed, not the figure for ideal conditions.
Choose the MCB type for lights
An MCB rating for a lighting circuit describes both the current and the trip curve of the device. UK MCB types B and C differ in how much inrush current they tolerate before tripping on a short circuit. Lighting with drivers or cold-filament lamps can draw a brief surge at switch-on, and a type C device rides through more of that surge than a type B. The final choice of curve and rating belongs to a qualified electrician who has seen the installation.
Questions about lighting circuit breakers
What size MCB for a lighting circuit?
The MCB size for a lighting circuit depends on the total lamp load and the cable that feeds it. A small circuit on a modest cable often takes a breaker of a few amps, while a larger circuit with heavier cable allows a higher rating. The rating must stay above the running current and at or below the cable's current capacity.
How do I work out the lighting circuit load in watts?
The lighting circuit load in watts is the sum of every lamp on the circuit. Add the wattage printed on each lamp or fitting, and include the draw of any driver or transformer. Compare that total with the current the chosen breaker allows at your supply voltage.
Does the breaker amp rating have to match the cable size?
Yes, the breaker amp rating must suit the cable size for the circuit to be protected. A breaker rated above what the cable can carry lets the cable overheat before the device trips. The cable's current capacity also changes with how it is run, so the installed route matters as much as the cable itself.
Should a lighting circuit use a type B or type C MCB?
A type B or type C MCB for lights depends on the inrush current of the fittings. Type C tolerates a larger short surge, which suits some driver-fed or cold-filament lighting. A qualified electrician should confirm the curve and rating against the installation.