Cable Tray Corner Fittings: Bends, Brackets, Joints and Connectors

Learn how cable tray corner pieces work: bends, brackets, joints and connectors that carry cables around a corner and keep a tidy route in a room.

3 min read1 viewsCable Tray Corner Fittings: Bends, Brackets, Joints and Connectors
— · 0 votes
Contents
  1. How a corner bend changes direction
  2. Corner brackets hold the turn in place
  3. Joints and connectors join tray sections
  4. Questions about cable tray corners
  5. What is a cable tray corner piece?
  6. How do I choose a cable tray corner connector?
  7. What is the difference between a corner bend and a corner bracket?
  8. Can I cut a straight tray to make a corner?

Cable tray corner fittings are the parts that let a tray route turn a corner instead of stopping or being cut and forced. A bend changes the direction of the run, a bracket holds the tray at the turn, and a joint or connector links tray sections so the cables stay supported. Choosing among these corner pieces starts with the tray width and the direction of the turn, not with the look of the fitting.

How a corner bend changes direction

A cable tray corner bend is a factory-formed elbow that turns the tray through a set angle, such as a right angle. The fitting radius is the curve the cables follow, and a wider radius lets stiff cables bend without kinking. A horizontal elbow turns the run across the floor plan, while a vertical bend changes its height. An inside bend fits the inner side of the turn and an outside bend fits the outer side, so the two are not swapped.

Corner brackets hold the turn in place

A cable tray corner bracket supports the tray at the point where it changes direction, where a straight run's supports no longer reach. The bracket fixes to the wall, floor or structure and carries the weight of the elbow and the cables above it. Bracket type depends on the mounting surface and on the tray width it has to hold. Load-bearing fixings need the right anchors for the wall or ceiling material, and a trained installer should confirm them.

Joints and connectors join tray sections

A cable tray corner joint or connector links the corner piece to the straight tray on each side of it. A splice plate is a flat plate that bridges two tray ends and bolts through the side rails. The tray joint connector must match the tray width and the rail pattern, or the holes will not line up. Correct joints keep the route continuous so cables rest on an unbroken surface at the corner.

Questions about cable tray corners

What is a cable tray corner piece?

A cable tray corner piece is the fitting that turns a tray run through a corner, joining two straight sections at an angle. It can be a bend, an elbow fitting with a set radius, or a short corner section that connects to the tray on both sides. The piece is matched to the tray width and to whether the turn is horizontal or vertical.

How do I choose a cable tray corner connector?

Choose a cable tray corner connector by matching it to the tray width, the rail hole pattern and the direction of the turn. The connector must join the corner piece to the straight tray so the side rails line up and the bolts pass through. Confirm the fitting radius suits the cables, since a tight turn can stress stiff cable.

What is the difference between a corner bend and a corner bracket?

A cable tray corner bend carries the cables around the turn, while a corner bracket supports the tray at that turn. The bend is part of the cable route and has a radius the cables follow. The bracket is a fixing that holds the elbow and its load against the building structure.

Can I cut a straight tray to make a corner?

Cutting a straight cable tray to form a corner is possible on site, but the cut edges and the joint need proper treatment. A factory corner bend or elbow fitting keeps the fitting radius even and saves the work of shaping the tray. Where the route carries heavy cables or needs a rated support, a trained installer should decide the method.

Latest articles