Built-In Refrigerator and Microwave Cabinet Opening Dimensions

How to size built-in refrigerator and microwave cabinet openings: measure depth, width and height from the appliance, then plan ventilation and service clearance.

3 min read0 viewsBuilt-In Refrigerator and Microwave Cabinet Opening Dimensions
— · 0 votes
Contents
  1. Depth: the figure that decides the layout
  2. Width and height from the cutout sheet
  3. Clearance for airflow and service
  4. Built-in opening questions answered
  5. What depth should a built-in refrigerator cabinet be?
  6. How deep is a microwave cabinet?
  7. What are typical built-in fridge cabinet dimensions?
  8. How much clearance does a built-in refrigerator need?

Built-in refrigerator and microwave cabinet opening dimensions come from the appliance, not from the cabinet drawing. You size each opening from the manufacturer's cutout sheet, which gives width, height, depth and the required ventilation clearance around the unit. The cabinet then gets built to those figures with a small allowance for the unit to slide in and be leveled.

Depth: the figure that decides the layout

A built-in cabinet depth refrigerator sits deeper than a counter-depth model, and the housing must match its body plus door and hinge swing. A counter-depth refrigerator is set so its doors sit near the cabinet face, while a fully integrated unit is hidden behind cabinet panels. Microwave cabinet depth follows the same logic: a built-in microwave needs a housing deep enough for its body and its door. Confirm the finished depth against the appliance spec sheet before you cut any panel.

Width and height from the cutout sheet

Appliance cutout width and appliance cabinet height are the two figures cabinetmakers need first. The cutout width is the clear inside measure between the cabinet sides, and the opening height is measured from the floor or shelf to the top of the opening. Add only the tolerance the appliance manufacturer allows for sliding and leveling the unit. An opening that is too tight stops leveling, and one that is too loose leaves gaps at the trim.

Clearance for airflow and service

Ventilation clearance and side and rear clearance keep a built-in appliance working and let a technician pull it for repair. The appliance sheet states where air must enter and leave, often at the toe kick, the top or the rear of the housing. A fridge housing dimensions plan that ignores those paths traps heat and shortens the life of the unit. Leave the service access the sheet requires, because a sealed box can turn a small repair into a cabinet removal.

Built-in opening questions answered

What depth should a built-in refrigerator cabinet be?

A built-in refrigerator cabinet depth comes from the appliance body, its door and the hinge swing, not from a standard number. Read the cutout depth on the manufacturer's sheet and add the panel thickness where the unit is integrated behind cabinets. A counter-depth refrigerator needs a shallower housing than a full built-in model, so confirm the figure for the exact unit.

How deep is a microwave cabinet?

A microwave cabinet depth depends on whether the microwave is built in, built under or set in a tall cabinet. The housing must fit the appliance body plus the door and any trim kit the maker supplies. Measure the microwave itself, then follow its cutout drawing for the inside depth before ordering cabinet panels.

What are typical built-in fridge cabinet dimensions?

Built-in fridge cabinet dimensions are set by the appliance cutout sheet, which lists opening width, height and depth for that model. Cabinet sides, shelves and panels are then built to those figures with the allowed tolerance for leveling. No single size fits every built-in refrigerator, so compare the sheet with your cabinet plan before cutting.

How much clearance does a built-in refrigerator need?

A built-in refrigerator needs the side, rear and ventilation clearances its manufacturer lists. Air must move in and out of the housing, and the unit needs room to slide in and be pulled for service. Build those gaps into the cabinet opening, because a tight box can block airflow and trap the appliance.

Latest articles