# Wire Connector Types Chart and Sizes

See how wire connectors are grouped by type and matched to wire gauge, with a size chart explained. Learn to read an AWG range and pick a connector that fits.

A wire connector types chart and sizes guide explains how each connector family is matched to a wire gauge, so you can read a size table and choose a part that grips the conductor correctly. The page groups the main connector types by how they join wires and by the AWG range each one accepts. It shows how to compare a connector size range against the wire gauge chart before you commit to a joint. 

## Reading a connector size chart 

A wire connector chart lists connector families beside the wire gauge each size accepts. The AWG range gives the smallest and largest conductor in American Wire Gauge, so a range like 22 to 14 AWG covers a span of conductor sizes. Match the connector size range to the actual conductor, not to the cable's outer jacket. Stranded wire can need a slightly wider range than solid wire of the same gauge. 

## Types grouped by connection method 

Connector types fall into groups by how they hold the conductor, such as screw terminals, push-in terminals, crimp terminals and twist-on nuts. A terminal block connector size refers to the conductor range its clamps accept and to its mounting pitch on the block. Screw and clamp blocks let you release and re-tighten a wire, while crimped and push-in joints are meant to be set once. Choose the connection method before you consult the size chart. 

## Matching gauge to connector range 

Conductor size matching means checking that the stripped wire sits fully inside the connector's rated AWG range. A wire thinner than the low limit can pull free under load, and a wire above the top limit may not seat at all. Measure the bare conductor with a wire gauge tool rather than judging by the insulation color. When a joint sits near the edge of a range, step to a connector whose range includes the gauge comfortably. 

## Questions About Wire Connector Sizing 

### What is a wire connector types chart for? 

A wire connector types chart pairs each connector family with the wire gauges it accepts so you can size a joint without guesswork. The chart shows the AWG range per connector size and the connection method of each type. Use it to compare a terminal block, a crimp terminal and a twist-on nut on the same conductor. Confirm the rating on the part itself before you connect a live circuit. 

### How do I find the right connector size for a wire? 

Finding the right connector size starts with measuring the bare conductor and reading its American Wire Gauge value. Compare that gauge against the connector's stated AWG range and pick a size that contains it. A connector size range that lists only one gauge fits only that conductor. Ask a qualified electrician when the circuit rating or the joint is unclear. 

### Do terminal block connectors come in different sizes? 

Terminal block connectors do come in different sizes, and the size covers both the conductor range and the block's pitch. The pitch is the spacing between adjacent poles, which sets how much room each wire has. A block rated for a narrow AWG range will not accept a thicker conductor even if the pitch looks generous. Check both figures on the datasheet before you mount the block. 

### Can I use a connector outside its AWG range? 

No, a connector should stay within its rated AWG range, because the clamp is built for those conductor sizes. A conductor below the range can work loose, and one above the range may not enter the terminal. Mismatched joints can heat up and damage the fitting or the wire. Have a trained specialist assess any joint that must carry a load beyond the connector's rating.
