# Wall Anchors for Light Fixtures

How wall anchors carry a light fixture in drywall: match the anchor load rating to the light fixture weight and mount through a junction box where wiring runs.

Wall anchors for light fixtures are fasteners that grip drywall or plasterboard so a fixture can hang where no stud sits behind the surface. The first decision is whether the light is wired, because a wired fixture needs a junction box at the mounting point. From there you match the anchor load rating to the light fixture weight and choose a hollow-wall anchor that spreads the load. 

## Match the anchor to the fixture weight 

Light fixture weight decides which anchor you can use, so weigh the fixture before you drill. A small flush mount or a lightweight sconce sits within the range of a threaded drywall anchor. A heavier pendant or a chandelier demands a hardware rating that exceeds the load, with a margin for pull and vibration. Check the anchor load rating printed on the pack and read it against the weight you measured. 

## Toggle bolts suit hollow drywall 

Toggle bolts are hollow-wall anchors that open behind the drywall and spread the load over a wider area. They hold better than a plain plastic plug in thin plasterboard, which crumbles under a point load. The bolt passes through the fixture base and the wall, then the toggle bar flips flat behind the board. A toggle bolt needs a hole wide enough for the bar, so plan the hole size before you commit. 

## Mount wired fixtures through a junction box 

A wired light fixture must connect inside a junction box, and the box carries the fixture rather than the bare drywall. Junction box mounting keeps the electrical connection protected and gives the fixture a solid metal or plastic frame to bolt to. Fix the box to a stud or to framing with appropriate fasteners, not to drywall alone. Where no framing sits behind the wall, a trained electrician or a specialist should set the support. 

## Questions About Wall Anchors and Lights 

### Can I use drywall anchors to hang a light fixture? 

Drywall anchors can hold a light fixture only when the fixture is light and unwired. A plug-in or battery fixture that hangs on a hook may sit on a rated hollow-wall anchor in sound drywall. A wired fixture cannot hang on drywall anchors alone because the connection needs a junction box. The anchor load rating must exceed the fixture weight. 

### What weight can wall anchors hold for a lighting fixture? 

The weight a wall anchor holds depends on the anchor type, the drywall thickness and the condition of the board. Plastic expansion plugs carry less than toggle bolts, and a toggle spreads its load over the widest area. Read the load rating on the product and keep the fixture weight below it with a margin for movement. Never load an anchor to its stated limit. 

### Do I need a junction box to hang a wired light on the wall? 

Yes, a wired light fixture needs a junction box at the wall so the electrical connection stays enclosed and supported. The box should be fixed to framing or a stud, with the fixture bolted to the box. Drywall anchors do not replace a box for a wired light. Have a qualified electrician make the connection. 

### Which anchor works best in plasterboard for a lamp? 

A toggle bolt works well in plasterboard for a lamp because its bar opens behind the board and spreads the pull. Plasterboard is soft and crumbles around a small plug, so a fastener with a wide bearing face holds better. Check the load rating against the weight of the lamp and its cord tension. Where the board feels soft or damp, replace the section or call a specialist.
