# LED Power Injector and Injection Connector: What to Buy and How to Wire It

Learn what an LED power injector and injection connector do, how to pick wire gauge and connectors, and how to wire a second power feed to a long LED strip run.

An LED power injector and injection connector are the parts that carry a second, fresh power feed to a long LED strip. The injector brings power from the supply, and the injection connector joins that feed to the strip at a chosen point. The pair solves voltage drop: the dimming that builds toward the far end of a run. This page explains what to buy and how to wire it. 

## Why a run needs a second feed 

Voltage drop is the loss of voltage along the copper traces of an LED strip. Those traces are thin, so a long run loses voltage and the far end looks dimmer and shifts color. An LED power injector adds a second path for current, so the far end sees a higher voltage. Injection points nearer the middle of a run reduce the distance current must travel. 

## Choosing the injector and connector 

An LED strip power injector is a small terminal that splits a supply feed into a lead you run to the strip. Its rating must exceed the current the section draws, so check the amperage on both the injector and the strip. An LED strip power injection connector should match the strip width and contact spacing, such as a two-pin or four-pin clip. Look at the wire gauge too, because undersized injection wire defeats the purpose of the feed. 

## Wiring the feed to the strip 

Switch off and disconnect the supply before any wiring work on an LED strip. Run the injection wire from the injector to the connector, then seat the connector firmly on the strip contacts with correct polarity. Join all negative returns to the same supply point to avoid a ground loop. If the supply, the mains side or the total load is unclear, have a qualified electrician check the circuit. 

## Questions about LED injection wiring 

### What is an LED strip power injector used for? 

An LED strip power injector feeds a second run of power into a long strip to counter voltage drop. It takes a supply feed and splits it into a lead that reaches an injection point along the strip. The result is a more even brightness from one end to the other. 

### How do I pick an LED strip power injection connector? 

An LED strip power injection connector must match the strip width, the contact spacing and the number of pins on the strip. Check that the connector carries the current of that section without heating. A mismatch in pin count or spacing causes a poor contact and an unreliable feed. 

### What wire gauge should the injection wire be? 

The wire gauge for power injection depends on the current of the section and the length of the injection lead. A longer lead or a higher current needs thicker copper to keep voltage drop low. Check the strip current rating and the lead length before choosing the gauge. 

### Where should I place power injection points on a long LED run? 

Power injection points work well near the middle and the far end of a long LED run. Placing a feed midway shortens the path current travels through the thin strip traces. Each point needs the same supply reference so the sections stay at one voltage.
