# LED Driver Size: How to Choose the Right Driver Size and Wattage

Learn how to size an LED driver by adding the load of every strip and light, then allowing headroom on wattage. Simple steps answer what size driver you need.

Choosing an LED driver size means adding up the wattage of every LED load on the circuit, then selecting a driver rated above that total. The driver must match the strip voltage and supply enough current for the full run, including any loss along long cables. This page explains the load calculation, the safety margin, and how to use a driver sizing calculator without guessing. 

## Add the load of every strip 

Start the load calculation by finding the wattage per length printed on each LED strip and multiplying it by the length you plan to run. Add the watts of every strip, spotlight and module that shares one driver to get the sum of LED load. A driver with a higher rating than that total leaves room for the strips to draw their rated power. Keep the figures per channel separate when one driver feeds several runs. 

## Match voltage and current 

A constant voltage driver must match the strip voltage, so a twelve volt strip needs a twelve volt driver. Current follows from the wattage and voltage, which is why a larger load calls for a driver with a higher current rating. Check that the driver output current sits above what the total load draws at that voltage. Mixing voltages between driver and strip prevents the lights from working correctly. 

## Allow headroom for the run 

A safety margin keeps the driver from running at its full rating for long periods, and it covers small differences between rated and actual load. Designers often aim to load a driver to part of its capacity, and the amount depends on the driver type and how enclosed it is. Voltage drop along long low voltage runs also raises the current the driver must supply. Add that loss to the load before you pick the final driver wattage. 

## Questions about LED driver sizing 

### What size LED driver do I need? 

The size you need is a driver rated above the total wattage of all LEDs on the circuit, at the same voltage as the strip. Add the wattage of each strip and light, then add a safety margin on top. The exact driver size depends on the total load and the voltage of your strips. 

### How does an LED driver size calculator work? 

An LED driver size calculator multiplies the watts per length by the strip length and adds every load you enter. It then applies a margin and returns a suggested driver wattage and current. The result depends on the figures you supply for strip wattage, length and voltage. 

### How do I size a driver for an LED strip run? 

Sizing a driver for an LED strip run starts with the strip wattage per foot or per meter and the length of the run. Multiply the two to get the strip load, then add the load of any other strips on the same driver. Choose a driver rated above that total at the strip voltage, with a margin for voltage drop. 

### Does a driver need extra wattage above the LED load? 

Yes, a driver should be rated above the LED load so it is not pushed to its limit. The extra wattage, called the safety margin, covers small load differences and the current added by voltage drop on long runs. The margin you allow depends on the driver type and how well its case is ventilated.
