# How to Replace a Lazy Susan in a Corner Cabinet

A plain guide to replacing a lazy susan in a corner cabinet: how to check the mount, remove the carousel shelf, fit a new swivel tray and test the swing.

Replacing a lazy susan in a corner cabinet means matching the new carousel shelf to the existing mount, taking the old tray out and fitting the replacement so it turns freely. The job stays simple when you identify the mounting type first, because a center post, a shelf-pin ring and a fixed baseplate each come out in a different way. You can plan the whole swap before you order any corner cabinet hardware, and this page walks through the check, the removal and the fitting. 

## Identify the mounting type first 

Corner cabinet hardware for a lazy susan attaches in one of a few ways, and the type decides how the tray comes out. A center post runs from the cabinet floor to the ceiling and holds the trays on a sleeve. A shelf-pin ring or a baseplate screws to the cabinet bottom and carries the carousel on a bearing. Look inside the cabinet with a light and note where the fixings sit before you touch anything. 

## Removing the carousel shelf safely 

Carousel shelf removal starts with emptying the tray and locking it so it cannot spin while you work. On a post system, loosen the set screw or lift the retaining clip at the top and slide the trays up and off. On a ring or plate system, unscrew the base fixings and lift the whole assembly out with a helper when the tray is wide. Wear gloves, because the edges of a loaded shelf and the post ends can catch a hand. 

## Fitting and testing the replacement 

A lazy susan replacement fits when the new tray matches the old mount footprint and clears the cabinet doors through a full turn. Set the base or post in place, fix it with the screws supplied for that mount, and set the trays at a height that clears the shelf above. Turn the tray by hand through its whole swing and check for rubbing on the door frame or the cabinet wall. If the door or the cabinet needs cutting or drilling, have a trained cabinet fitter do that work. 

## Questions about corner cabinet lazy susans 

### Can I replace just the tray and keep the old mount? 

Yes, you can replace only the tray when the existing mount is sound and the new swivel tray matches its fitting pattern. Check the post diameter or the screw spacing on the ring before you buy, because a tray built for a different mount will not seat. If the bearing feels rough or the post is loose, the mount is the part to change. 

### Do I need to remove the cabinet door to swap a lazy susan? 

No, the cabinet door can usually stay on while you swap a lazy susan in a corner cabinet, and taking it off only helps when the opening is narrow. A wider tray may need the door off its hinges to pass through the frame. Set the door aside safely if you remove it, and refit it after the new tray turns without rubbing. 

### What do I measure before ordering a replacement lazy susan? 

Measure the inside width of the cabinet opening, the depth to the corner and the diameter of the old tray before ordering a lazy susan replacement. Note the mount type as well, since a center post, a shelf-pin ring and a baseplate each need a matching tray. A tray that is too wide will rub the door frame, so keep a small gap at the edge. 

### Why does my new lazy susan rub or stick when it turns? 

A new lazy susan sticks when the mount sits off center or the tray is set too high or too low for the cabinet. Loosen the fixings, center the base or post in the corner, and check the tray clears the shelf above and the door below. A bearing that still binds after centering points to a damaged mount rather than the tray.
