# How to Measure Crown Molding Corners and Miter Cuts

Measure wall corner angles, set crown molding miter cuts on a miter saw, and check spring angle and fit at inside and outside corners.

Measuring crown molding corners means finding the angle where two walls meet, then splitting that angle for the miter cut. The page shows how to measure a wall corner with a bevel gauge or protractor, how the spring angle changes a cut, and how inside corners are finished by coping rather than a tight miter. 

## Reading a wall corner angle 

A wall corner angle is measured across the opening between the two faces, not along either wall. Hold a bevel gauge in the corner, tighten its lock nut, and read the angle against a protractor on a flat surface. Square corners read as a right angle, but a room can be out of square, so record each corner on its own. The miter cut angle is half of that reading, which the saw scale can take if the saw reads from square. 

## Spring angle and the miter saw 

Crown molding leans against the wall and ceiling at a spring angle, so a cut is not a simple flat miter. The molding can rest against the saw fence in its installed position, or lie flat with a compound miter angle set on both tilt and swing. Either method needs the correct spring angle, and repeated test cuts on a scrap piece confirm the profile meets as planned. A digital angle finder helps, but the fit of the test piece is the proof. 

## Inside corners and coping 

An inside corner tends to gather small errors, so one piece is often coped rather than mitered to a point. Coping means cutting the profile outline on the end of one length so it sits over the face of the other piece. The joint hides movement and the unevenness of a corner angle better than a tight miter. Trim corner cuts at outside corners still need a true miter, cut to half the measured angle. 

## Questions about crown molding corners 

### How do I measure angles for crown molding? 

Measure angles for crown molding at each wall corner with a bevel gauge or protractor, then halve the reading for the miter. Write the number on the wall beside the corner so you cut each piece to its own corner. The spring angle of the molding matters as much as the corner angle, so check it before setting the saw. 

### How do I measure crown molding inside corners? 

Crown molding inside corners are measured like any corner, but the joint is often coped instead of mitered. Measure the corner angle, then cut one piece square and shape the end of the second piece to the profile of the first. This coping cut covers the gap that a miter would leave in an off-square corner. 

### How do I cut mitered corners on crown molding? 

Cut mitered corners on crown molding by holding the molding at its spring angle against the saw fence. Set the saw to half the measured corner angle and test on a scrap piece first. For a compound miter angle, lay the molding flat and set both the bevel and the miter, then check the fit before cutting the final length. 

### Do I use the same angle for baseboard and crown trim? 

A baseboard miter cut and a crown molding miter cut do not use the same setup, though both start from the corner angle. Baseboard sits flat against the wall, so its miter is half the measured angle on the saw scale. Crown molding adds the spring angle, which changes the cut unless the molding is braced in its installed position.
