# Door Opening Force Requirements

Learn what door opening force requirements mean for accessible doors and how to measure the force needed to open a door with a simple push-pull gauge method.

Door opening force requirements describe the maximum push or pull a person should need to move a door, and the page explains how to measure that force yourself. It covers the accessible door hardware side of the question and shows where a door closer changes the reading. You will see the steps for a repeatable measurement and the limits that apply to accessible routes. 

## What opening force measures 

Door opening force is the push or pull needed to swing a door from rest to fully open. It is read in pounds of force at the handle or at a marked point on the door face. The reading reflects the door weight, the hinge friction and the door closer acting against you. Measure the force to open a door rather than the force to hold it open, because the two values differ. 

## Steps to measure the force 

A push-pull gauge reads the force to open a door when you pull steadily at the handle. Attach the gauge, pull slowly and perpendicular to the door face, and note the peak value as the door starts to move. Repeat the pull a few times and keep the highest steady reading, since a jerky pull inflates the number. The same method works with a force gauge pressed flat against the door if no handle is reachable. 

## Accessible limits and hardware 

The ADA opening force limit for interior accessible doors is generally five pounds of force, with exterior doors allowed more. That limit applies to accessible door hardware on a route a wheelchair user can follow. A door closer is the part that sets the closing speed and the resistance you feel, so adjust it before you blame the hinges. Certified testers measure and record the value where a code inspection requires proof. 

## Questions about door opening force 

### How do I measure door opening force? 

Measure door opening force with a push-pull gauge held at the handle and pulled slowly until the door moves. Read the peak value, repeat the pull a few times and keep the highest steady number. Pull perpendicular to the door face so the gauge measures the true force to open a door. Record each reading with the door position set the same way every time. 

### What is the ADA opening force limit for a door? 

The ADA opening force limit is five pounds of force for interior doors on an accessible route. Exterior doors carry a higher limit because they must resist wind and weather. The rule covers accessible door hardware rather than every door in a building. A door with a heavy closer can exceed the limit and still look fine, so the reading matters more than the look. 

### Does a door closer change the force needed? 

A door closer changes the force needed to open a door because its spring resists the swing. Adjusting the closer spring and the closing speed lowers the reading at the handle. If the reading stays high after an adjustment, check the hinges and the door alignment before replacing hardware. A closer set too strong will keep pushing the door beyond the limit. 

### Can I measure the force without a gauge? 

No, a force gauge is needed to measure pounds of force, because a hand cannot report a number. A spring scale rated for the expected load can serve the same purpose when attached at the handle. Read the scale as the door begins to move, not after it is already swinging. For a formal check, a trained specialist records and certifies the result.
