# Corner Protector Length Calculator

Work out how much corner protector to buy by measuring the corner edges you want to cover, then adding the length each cut piece needs for a secure fit.

A corner protector length calculator turns a few measurements into a shopping number for corner guards. You measure the edge length each guard must cover, count the corners, and add a small allowance per piece for the wrap around the point. The result is the total length of protector material to buy for furniture corners and wall edges in the room you have. 

## Measure each corner edge first 

Measuring corner edge length starts at the point of the corner and runs along one face of the edge. Record that distance on both faces, because a guard wraps around the point and covers the same span on each side. Note the thickness of the panel or top as well, since a thick top needs a wider strip to sit flat. Write each measurement down as you go so no corner is counted twice. 

## Use a simple length formula 

The corner guard length formula adds the two face measurements, the panel thickness, and a small allowance for the curve at the point. A simpler estimate is the face length on one side, doubled, plus an allowance for thickness and wrap. Estimator tools for protector length use the same idea and multiply per-corner needs by the number of corners. Round up to the next whole unit when you place the order. 

## Match strips to what you buy 

Corner protector material is sold by the length of strip or by the pack, so the total length tells you how much to buy. Divide the total by the length of a single strip to see how many pieces the job needs. A cut from a long roll gives less waste than fixed strips when corners differ in size. Estimate protector length for each corner separately, then add the figures together before dividing. 

## Corner protector measuring questions 

### How do I measure a corner for a protector? 

Measure a corner for a protector by holding a tape along each face of the edge, starting at the point. Note the same span on both sides and add the thickness of the panel between them. That total is the strip length the corner needs, before any allowance for wrap. 

### How much corner protector should I buy? 

Buy corner protector in the total length your corners add up to, with a little extra per piece. Count every corner you want to cover, work out each strip length, and add the strips together. Divide by the strip length you buy to get the number of pieces. 

### What is the corner guard length formula? 

The corner guard length formula adds the covered length on each face to the panel thickness and a wrap allowance. Some guards need only one face length, doubled, plus thickness, so check the shape of the guard. The formula gives a cut length per corner rather than a room total. 

### Does the calculator allow for waste when I cut strips? 

A length calculator allows for waste only if you build it into the figure yourself. Add a margin to each strip where corners differ in size or where cuts must be trimmed to fit. Trimmed ends and offcuts from fixed strips reduce the usable length of a roll.
